Vaporesso TARGET 200 Overview
Although it needs two 18650 batteries (sold separately) to power, it is surprisingly compact. The cage-like frame makes it more durable while still comfortable in-hand. This design also helps the kit against water damage. All the settings are shown on a 0.96inch screen such as battery life and output power. It comes with two GTi coils. The 0.2ohm coil is best at 60-75W and the 0.4ohm 50-60W. Both are made with mesh to heat up more e-liquid at a quicker rate. When the batteries run out of power either swap them out or use the USB-C cable to recharge them quickly.
How to Use?
- Open the base of the mod and insert two 18650 batteries.
- Fit the coil by removing the tank from the kit, then the 510 base. Push the coil firmly into place at the bottom of the tank then reattach the base and screw back onto the kit.
- To fill the tank slide the top to reveal the e-liquid inlet. Top it up with liquid making sure not to overfill. Then slide the top back and allow the coil to prime.
- The airflow adjusts by twisting the ring on the bottom of the tank. This will reveal large air inlets that are suitable for both direct lung and restricted DL vaping.
- Switch on the device by clicking the power button 5 times. Adjust the settings to the right output wattage using the buttons below the screen, then vape.
Who Should Buy This Kit?
The water-resistant design makes this great for vapers who work in tough environments. The coils are both great for direct lung vaping and produce thicker clouds thanks to the mesh build. When paired with high VG e-liquid it creates large clouds full of flavour. Plus, the draw is easy and less noisy than other sub-ohm kits.
- 1 x Vaporesso TARGET 200 mod
- 1 x Vaporesso iTank
- 2 x GTi coils
- 1 x USB-C charging cable
- 1 x Spare glass tube
- 3 x O-rings
- 1 x User Manual
Vaporesso TARGET 200 Specifications
- Tank capacity - 2ml
- Coil resistance - 0.2ohm mesh / 0.4ohm mesh
- Battery capacity - 2 x 18650 (sold separately)
- Output range - 5-220W
- Dimensions - 142.1mm x 42.8mm x 33.7mm